IMPORTANT: PRODUCTS ARE ONLY SHIPPED WITHIN THE CONTINENTAL USA

Contact us for volume pricing!

VSU - 485G-iQ

Serial Converter for iQpump SCADA

The VirtualSCADA VSU-485G-iQ is an isolated USB to RS422/485 converter that can be used with iQpump SCADA software for communication between a PC and the iQpump Intelligent Pump Controller

VSU-485G iQpump Quick Setup guide (PDF, 484 KB)

VS1 - SCADA - iQpump Edition

VirtualSCADA VS1 for iQpump gives users local or remote access to an iQpump Intelligent Pump Controller System by using a standard internet web-browser. VirtualSCADA VS1-iQ module is able to connect via Ethernet, Internet, LANs, Telephone modems, GSM and GPRS networks. Turn key and Ready to Use : All Virtual SCADA iQpump modules come preloaded with the iQpump template and are ready for immediate use, so no additional setup or programming is required.

Note: This device is pre-loaded for use with iQpump

VS1-iQ Brochure (PDF, 813 KB)

VS1 iQpump Quick Start for RS485 (PDF, 507 KB)

VS1 iQpump Quick Start for CM090 (PDF, 484 KB)

US$ 695

VS2 - Communication Gateway

VirtualSCADA VS2 for Industrial and HVAC SCADA Applications gives users the ability to connect a Modbus/TCP master (e.g. PLC system) to one or more devices with a Modbus RTU connection. The transparent VirtualSCADA VS2 gateway will act as a Modbus/TCP slave on an Ethernet network, transform the queries to the Serial Modbus network and send back the response to the Modbus/TCP master. The VirtualSCADA VS2 can be setup in a matter of minutes.Turn key and ready to use.

VirtualSCADA VS2 Brochure (PDF, 464 KB)